I found some military documents that reinforces the military history of 008, It had to be converted to a left hand tail rotor, I am currently looking for the pitch arm plates for the tail rotor control
david hillberg, e-mail, 29.08.2023 21:52
this year I started an annual of Serial # 008, four items were missing, right fuel tank, control tube, baggage compartment and logbooks, Due to the few life limited components and the condition of all what has been seen so far, not in bad shape, all the MSBs and SIBs are currently being evaluated and incorporated. All ADs are either already complied with or will be done, two 337s were submitted and three more will be added at the conclusion of the inspection/maintenance. I reserved the original N number of N193E and will repaint the cabin to reflect its original scheme.
Czigany, e-mail, 20.05.2021 09:26
We are adopting a new airworthiness directive (AD) for the Enstrom Helicopter Corporation (Enstrom) Model F-28, F-28A, F-28C, F-28C-2, F-28C-2R, F-28F, F-28F-R, TH-28, 280, 280C, 280F, 280FX, 480, and 480B helicopters. This AD requires inspecting certain rod end bearing assemblies. This AD is prompted by an accident. The actions of this AD are intended to prevent an unsafe condition on these helicopters.
RUFUS, e-mail, 09.03.2017 11:03
THE PROPULSION SYSTEM OF THIS CHOPPER,IS IT PISTONED OR TURBO-SHAFT?
RUFUS, e-mail, 09.03.2017 11:01
HOW MAIN ROTOR WORKS HENCE I DON'T SEE LINKAGE LIKE CONVENTIONAL HELICOPTER?
ghassen, e-mail, 04.03.2015 13:37
can you send to me a design for the small hellicopter ??? i mean dessin technique if you can ??
David Styer, e-mail, 15.03.2011 21:54
N756H is presently located in Pendleton Oregon and is back to the paint scheme as shown in the picture.
Doink pilot Don, e-mail, 26.05.2010 07:14
N756H was a Hiser helicopter flew it lots of hours,Now it painted white after the turbo lost boost ant it was rolled up south of the south side grass AJO corona Ca
john marvin, e-mail, 02.09.2008 22:06
my father rented a cabin from rudy for years..I am 68 years old and sit in rudys tethered machine in crystal falls mi. he was quite a guy
James Mullins, e-mail, 31.03.2007 22:25
What is the operating cost per hour for a 280C including reserves?
